Renault ABS Sensor Plate User Manual

For the following vehicles

40mm Centre Diameter

  • Renault Megane II (2002-2009) (Convertible, Estate, Hatch)
  • Renault Scenic II (2002-2009) (not Grand Scenic)

45mm Centre Diameter

  • Renault Espace IV (2001-2009)
  • Renault Laguna II (2002-2009)
  • Renault Grand Scenic II (2002-2009)
  • Renault Megane III (2007-2018)
  • Renault Scenic III (2007-2018)
  • Renault Grand Scenic III (2007-2018)
  • Renault Laguna III (2007-2018)

You Will Receive

1 or 2 x ABS Plate made of marine grade stainless steel

Supplies

You will need:
Small & large flat-head screwdrivers or chisels Hammer
Wire brush
Penetrating spray

You may need:
Blow torch or heat gun Spot welder

Renault ABS Sensor Plate 40mm & 45mm Manual

Step 1: Get Prepared

To uncover the steering knuckle and spindle where the initial ABS plate is located (or where it used to be if it has deteriorated), take off the wheels, brake caliper, and disc from the vehicle. If required, detach the ABS sensor from the plate.

Step 2: Apply the Penetrating Spray

Apply the penetrating spray generously to the plate and leave to soak for 1-2 hours. This will loosen the plate and make it easier to remove.

Step 3: Remove the Original Plate

Begin tapping around the outer edge of the plate with a flathead screwdriver, chisel, and hammer, making sure to cover the entire perimeter. Starting with a larger screwdriver and then switching to a smaller one later on made the process easier for us. When the plate is entirely detached, take it off of the spindle. If you are experiencing difficulty removing the initial plate, a blow torch or heat gun can assist in the procedure. It may be securely attached due to corrosion on the knuckle and plate.

Step 4: Wire Brush the Area

Using a wire brush, brush down the knuckle & spindle area of any surface corrosion. Try to be as thorough as possible so the new plate can fit flush to the knuckle.

Step 5: Apply the New ABS Plate

Position the new ABS plate over the spindle, making sure that the sensor connector is in the appropriate spot. The new plate should fit snugly and securely against the knuckle. If it does not, we recommend utilising a spot welder to fasten it to the spindle. There are two openings in the middle of the new plate designed specifically for spot welding (if required).

DSC_0601

Step 6: Connect the ABS Sensor

Connect the ABS sensor to the connector on the new plate and rebuild the vehicle. The car may need to be plugged into a diagnostic machine to clear the ABS fault on the dashboard.

Buy Replacement Car Parts Online Today

Scroll to Top
Scroll to Top